Table of Contents
Advertisement
Disassembly procedure
1)
Fix the disk motor with the disk drive motor fixing
screws. (Screw tightening torque: 5.0 kg-cm)
2)
Mount the endless belt on the disk drive motor
pulley, idler bearing and disk drive pulley in that
order. (Fig. 2-42)
3)
Fix the slide shaft 8 holder to the VCM unit with
the slide shaft 8 holder fixing screw.
4)
Mount the sub-frame. (Refer to 2.5.3)
5)
Mount the main board' set. (Refer to 2.5.1 )
6)
Check the disk speed. (Refer to 3.4.2)
Note 1. Check the disk rotates smoothly without
generating abnormal noise .
. Note 2 Check the belt is not frayed or cracked.
Idler
Notes on disassembly
Disk drive motor
Disk drive pulley
2-25
Advertisement
Chapters
Table of Contents
