Disassembly procedure
1) Check the head lead wire follows the specified
route. (Fig. 2-25)
2) Check each connector is in the correct position,
and set the main board set.
3) Tighten the main board set fixing screws.
Tightening torC"ue: 4.0 kg· m for A -- 0
Fig. 2-26
2-15
Notes on disassembly
Note 1. Take care not to damage the terminal
when the connector is connected or dis-
connected.
Note
21.
If the VCM connector does not coincide
with the main board connector, loosen the
VCM flexible lead plate fixing screw a lit-
tle, adjust the connectors and then re-
tighten the screw. (Fig. 2-26)
Note 3. Before tightening the main board fixing
screws, make sure that the head lead wire
is not trapped by the front panel.