Table of Contents
Advertisement
Disassembly procedure
6. Note: Upper and lower cases are connected via the
grounding wire.
lift
the upper case by hand and remove it so that
the rear part come to the front, and put it in front of
the lower case.
7. Remove the screw on the right side of the
speaker of
Q
10 SYM board, and disconnect
the grounding wire.
CTC: M3 x 12 x 1
•
Carry out above procedure in reverse for
reassembly.
2-3
Notes on disassembly
• The CN6 us 1 Upper case lock type, and should be
removed by opening left and right levers.
• When replacing, make sure the cables of CN7 and
CN7 are not trapped by the case or Q 1 0 GMS
board.
Lower
case
Groundi
wire
Upper
1 " : : 1 < : : 1 " - - - - -
Fig. 2-5
Fig.
2-6
• When replacing, make sure the cables of CN7 and
CN7 are not trapped by the case or
Q
10 GMS
board.
Fig. 2-7
•
The tightening torque is 5 kg·cm.
Advertisement
Chapters
Table of Contents
