Epson QX-10 Technical Manual page 39

2.5.5 Disk guide (L) unit, write protect detector set and eject transmission level
Disassembly procedure
1) Remove the main board set (Refer to 2.5.1 )
2) Remove the sub-frame unit. (Refer to 2.5.3)
3) Remove the front panel fixing screws and take off
the front panel by pulling it to the front. (Refer to
2.5.4)
CS M2.5 x 4 x 2
4)
Remove the disk guide
(L)
unit fixing screw, and
take off the disk guide (L) unit from the main unit.
5)
Remove the write protect detector fixing screw,
and take off the write protect detector from the
disk guide
(L).
6)
Push the slide lever push button hook up, and re-
move the pushbutton.
'Disk guide sleeves
Pushbutton hook
~/
.
PUShbutton"" /
~
. Write protect detector.
~
Fig. 2-34
2-21
Notes on disassembly
~DiSk guide
(Ll
unit fixing screw
I
i