Table of Contents
Advertisement
2.5.7 Disk guide (R), idler set and disk drive pulley set
Disassembly procedure
1)
Remove the main board set. (Refer to
2~5.1
)
2)
Remove the sub-frame unit. (Refer to 2.5.3)
3)
Remove the endless belt.
4)
Remove the idler fixing screw. Remove the flat
washer and idler bearing. (Fig. 2-43)
CP: M3 x 7 x 1
5)
Remove the disk guide sleeve from the disk guide
(R).
6)
Remove the disk guide (R) fixing screws. (Fig.
2-44)
.
cs:
M2.5 x 8 x 2
7)
Remove the disk drive pulley screw. Remove the
disk drive pulley set.
@
I
Idl~~~
I
Fig. 2-43
2-26
Notes on disassembly
Fig. 2-44
Advertisement
Chapters
Table of Contents
