Yamaha fwx120 Operation Manual page 148

Operating and managing the product
Load a configuration file included
in an external memory device from
"Basic configuration page"
1
Prepare an external memory device
storing a configuration file.
2
Insert the external device into the USB
port or microSD slot of the product.
The USB lamp or microSD lamp of the product
lights up or flashes.
3
In the "Source file name to copy" field
7
on the "Copy configuration and firmware
files" screen, specify the file name you
want to load from the external memory
device to the product.
To open the "Copy configuration and
firmware files" screen
From "Basic configuration page", click the buttons
on the setup screen in the following order:
 "Advanced settings" in the top page
 "Execute" of "Copy configuration and
firmware files"
4
In the "Copied file name" field, select
"Internal non-volatile memory" and
specify a config number.
Tip
If you specify another external memory device
instead of "Internal non-volatile memory", you can
copy the configuration file to the external device
using the product.
148  FWX120 Operation Manual
5
Click "Execute".
A confirmation screen appears.
6
Click "Execute".
The configuration file prepared in Step 1 is
loaded to the product. After the configuration
file has been loaded, the product restarts
automatically.
After the restart, the product operates using
settings of the loaded configuration file.
NOTE
If "allow" is selected in the "Startup via external
memory" field on the "Configure external
device" screen, the product starts by using the
configuration file in the external memory device.
In this case, do not remove the external device.
7
Hold down the USB button or microSD
button for two seconds.
The USB lamp or microSD lamp of the product
goes off.
8
Remove the external memory device.
NOTE
If loading the configuration file from the external device
fails, refer to "Unable to use USB device" (page 178).