Table of Contents
Advertisement
Enhancing security
Change the policy set manually
In the "Configure and view the status of policy filter"
screen, click the "Operation" field of the policy set
you want to enable to select it.
4
For more details on the settings, click "Help" on the
setup screen and refer to the description displayed.
To open the "Configure and view the status of
policy filter" screen
From "Basic configuration page", click the buttons
on the setup screen in the following order:
"Advanced settings" in the top page
"Configure" in "Configure policy filter"
"Execute" of the interface for which you want to
view the policy filter
(Click "Execute" of "Configure and view status
of IPv4 policy filter" if IPv4 addresses are used
for connection, or "Execute" of "Configure and
view status of IPv6 policy filter" if IPv6 addresses
are used.)
84 FWX120 Operation Manual
Set criteria for changing the policy
set automatically
In the "Configure policy set switching" screen,
you can set criteria for changing the policy set
automatically.
NOTE
The "Configure policy set switching" screen is visible
only if multiple policy sets are created.
For more details on the settings, click "Help" on the
setup screen and refer to the description displayed.
To open the "Configure policy set switching"
screen
From "Basic configuration page", click the buttons
on the setup screen in the following order:
"Advanced settings" in the top page
"Configure" in "Configure policy filter"
"Execute" of the interface for which you want to
view the policy filter
(Click "Execute" of "Configure and view status
of IPv4 policy filter" if IPv4 addresses are used
for connection, or "Execute" of "Configure and
view status of IPv6 policy filter" if IPv6 addresses
are used.)
"Add" of the policy set you want to set criteria in
the "List of policy set" section
Advertisement
Table of Contents
