Yamaha fwx120 Operation Manual page 120

Hide thumbs Also See for fwx120:
Table of Contents

Advertisement

Implementing site-to-site VPN connections
Gaining remote access using PPTP
(Continued from the previous page)
Accessing the product
1
Connect the product to the broadband
network.
2
Click "View network status and tasks"
in "Control Panel".
3
Click "Connect to a network".
5
4
Select "VPN_PPTP" icon and then click
"Connect".
5
Click "Properties".
6
Click "General" tab and check that
the host address obtained with the
netvolante DNS service or the WAN
IP address of the product has been
entered in "Host name or IP address of
destination".
120  FWX120 Operation Manual
7
Click "Options" tab, and then click "PPP
Settings".
8
Select the check box as shown below
and then click "OK".
• Enable LCP extensions: Unchecked
• Enable software compression: Unchecked
• Negotiate multi-link for single-link
connections: Checked
9
Click "Security" tab and then select
"Automatic" for "Type of VPN".
10
Select the encryption mode.
If you selected "PP" as an encryption mode you
want to use in Step 3 on page 118, select the
encryption mode according to the setting you
made in Step 4 on page 118.
• If "Non-encrypted access denied" is
selected with the product: Select "Require
encryption (disconnect if server declines)".
• If "Non-encrypted access allowed" is
selected with the product: Select your
desired encryption level.
If you selected "Anonymous" as an encryption
mode you want to use in Step 3 on page 118,
select your desired encryption level.

Advertisement

Table of Contents
loading

Table of Contents