Chapter 4 Chassis Setup And Maintenance; Overview; Removing Power From The System - Supero SC811TQ-600B User Manual

4-1

Overview

This chapter covers the steps required to install components and perform mainte-
nance on the chassis. The only tool required is a Phillips screwdriver.
Review the warnings and precautions listed in the manual before setting up or
servicing this chassis. These include information in Chapter 2: System Safety and
the warning/precautions listed in the setup instructions
4-2 Removing the Power from the System
Before performing any setup or maintenance on the chassis, use the following
procedure to ensure that power has been removed from the system.
1. Use the operating system to power down the node, following the on-screen
prompts.
2. After the system has completely shut-down, carefully grasp the head of the
power cord and gently pull it out of the back of the power supply. If your sys-
tem has dual power supplies, remove the cords from both power supplies.
3. Disconnect the cord from the power strip or wall outlet.
Chapter 4: Chassis Setup and Maintenance
Chapter 4
Chassis Setup
and Maintenance
4-1