Table of Contents
Advertisement
SC811 Chassis Manual
3-2
Control Panel Buttons
There are two push-buttons located on the front of the chassis. These are (from left
to right) a reset button and a power on/off button.
•
Reset: The reset button is used to reboot the system.
•
Power: The main power switch is used to apply or remove power from the power
supply to the server system. Turning off system power with this button removes
the main power but keeps standby power supplied to the system. Therefore,
you must unplug system before servicing.
3-3
Control Panel LEDs
The control panel located on the front of the SC811 chassis has five LEDs. They
provide you with critical information related to different parts of the system. This sec-
tion explains what each LED indicates when illuminated and any corrective action.
•
Information LED: Alerts operator of several states, as noted in the table below.
Status
Continuously on and red
Blinking red (1Hz)
Blinking red (0.25Hz)
Solid blue
Blinking blue
Informational LED
An overheat condition has occured.
(This may be caused by cable congestion.)
Fan failure, check for an inoperative fan.
Power failure, check for a non-operational power supply.
Local UID has been activated. Use this function to locate
the server in a rack mount environment.
Remote UID is on. Use this function to identify the
server from a remote location.
3-2
Description
Advertisement
Table of Contents
