Belt Tension - Technogym BIKE XT Service Maintenance Manual

8.2. BELT TENSION

Figure 8.2-1
Figure 8.2-2
Page 8.2
BIKE XT: Service & Maintenance manual - rev. 2.0
Carry out the procedure described in paragraph
7.7. "Disassembling the right and left side
casings".
1. Back off lock nut a of alternator pivot b
using a 19-mm wrench.
2. Back off dowel c of alternator pivot b.
3. Back off nut e of belt tension rod d using a
17-mm wrench.
4. Rotate the alternator on its pivot axis in such
a way that, at point A, belt f has a vertical
play of approximately 1 cm.
After completing this operation, check
the belt tension again.