Technogym BIKE XT Service Maintenance Manual page 42

Version A:
Figure 7.10-3
Figure 7.10-4
Page 7.12
BIKE XT: Service & Maintenance manual - rev. 2.0
From the left-hand side of the machine:
4. Use a marker pen to fix a reference point
between cam e and the machine frame.
5. Unscrew the 2 screws f which clamp cam e
on the frame using a 4-mm hex T wrench.
6. Remove cam e.
7. Remove BELT g from the guide of pulley h.
8. Remove snap ring i using the special pliers.
9. Use a pointed tool to push pin l inward,
taking care to recover the Teflon spacer and
the washers if present, until there is sufficient
space for the BELT to pass through.
10. Remove the BELT.
To reassemble the BELT, carry out the above
steps in reverse order.
After completing the procedure, adjust
the alignment and tension of the belt as
instructed in paragraphs 8.1. 8.2. .