Disassembling The Alternator - Technogym BIKE XT Service Maintenance Manual

7.9. DISASSEMBLING THE ALTERNATOR

Figure 7.9-1
Figure 7.9-2
Page 7.10
BIKE XT: Service & Maintenance manual - rev. 2.0
Carry out the procedure described in paragraph
7.7. "Disassembling the right and left side
casings".
1. Disconnect the
ALTERNATOR.
2. Loosen nut c of belt tension rod b using a 17-
mm wrench.
3. Unscrew bolt a which fixes belt tension rod b
to the machine frame using a 17-mm wrench.
4. Loosen dowel f using a 4-mm hex T- wrench.
5. Move the ALTERNATOR until belt g can be
removed.
To facilitate the operation, the belt can
first be removed from the pulley.
6. Loosen lock nut d of alternator pivot e using
a 19-mm wrench.
7. Unscrew alternator pivot e using an 8-mm
hex T wrench. At the same time, back off
lock nut d until it is disassembled.
8. Remove the ALTERNATOR.
To reassemble the ALTERNATOR, carry out the
above steps in reverse order.
After completing the procedure, adjust
the belt tension and alignment as
described in paragraphs 8.1. 8.2. .
cables from the