Disassembling The Right And Left Side Casings - Technogym BIKE XT Service Maintenance Manual

7.7. DISASSEMBLING THE RIGHT AND LEFT SIDE CASINGS

Figure 7.7-1
Figure 7.7-2
Page 7.8
BIKE XT: Service & Maintenance manual - rev. 2.0
Carry out the procedure described in paragraph
7.6. "Disassembling the saddle stem guard".
1. Unscrew the 7 self-tapping screws a which
fix the LEFT SIDE CASING using a large
Phillips screwdriver.
2. Remove screw b using a large Phillips
screwdriver, while using another large Phillips
screwdriver to hold the opposing screw on
the RIGHT SIDE CASING in place.
3. Unscrew the 7 self-tapping screws which fix
the RIGHT SIDE CASING using a large
Phillips screwdriver.
4. Push the right pedal toward the rear of the
machine and remove the RIGHT SIDE
CASING, using your right hand to help
separate the 2 SIDE CASINGS.
Place your hand exactly as shown in the
figure at left
5. Push the left pedal towards the back of the
machine and remove the LEFT SIDE
CASING.
To reassemble the SIDE CASINGS, carry out
the above steps in reverse order.
It is also possible to disassemble only one
of the 2 SIDE CASINGS.