Montaż Układu Automatycznego Resetowania; Montaż Mechanizmu Resetowania - Siemens Sentron WL Operating Instructions Manual

Circuit-breaker
Table of Contents

Advertisement

10.3
Montaż układu automatycznego resetowania
Wykorzystując układ automatycznego resetowania blokady
ponownego załączenia, elektromagnes wyzwalający zostaje
automatycznie zresetowany po wyzwoleniu przez modułu
przetężeniowy. Wyłącznik jest natychmiast gotowy do ponownego
załączenia. Wskazanie wyzwolenia oraz sygnał wyzwolenia muszą
zostać zresetowane ręcznie w module przetężeniowym lub też
wykorzystując elektromagnes zdalnego resetowania.
OSTRZEŻENIE
Zagrożenie mechaniczne!
Mechanizm może spowodować poważne zranienia,
jeśli zostanie zdjęta osłona.
Wyłączyć i zwolnić sprężynę załączającą przed
  (strona 24-2)
zdemontowaniem osłony
- Wyjąć moduł połączeniowy X5
- Wcisnąć przycisk OPEN
- Wcisnąć przycisk CLOSE
- Ponownie wcisnąć przycisk OPEN.
- Zdjąć przedni panel
- Zdemontować moduł przetężeniowy
10.3.1 Montaż mechanizmu resetowania
Demontaż elektromagnesu wyzwalającego F5
Mocowanie układu wyzwalającego, wykonane z metalu
(srebrnego koloru):
1
1
Odciągnąć zatrzask w kształcie haczyka
2
Zdemontować elektromagnes wyzwalający
10 – 3
:
  (strona 24-8)
  (strona -82)
10.3
Retrofitting automatic reset
With the automatic reset of the closing lock-out the tripping solenoid
is automatically reset after the overcurrent release has tripped.
The circuit-breaker is immediately ready to close again. The tripped
indication and the tripped signal must be reset either manually on
the overcurrent release or by means of the remote reset magnet.
WARNING
Mechanical hazard!
Mechanism can cause severe injury when cover is removed.
Switch off and discharge the storage spring before removing
  (page 24-2)
cover
- Remove hand plug X5
- Push OPEN button
- Push CLOSE button
- Push OPEN button again.
- Remove front panel
- Remove overcurrent release
10.3.1 Installing reset mechanism
Removing tripping solenoid F5
Trip unit system carrier, made of metal (silvery colour):
2
1
Push snap-action hook back
2
Remove tripping solenoid
:
  (page 24-8)
  (page -82)

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents