Outrigger Cylinder; Bodily Injury Hazard. Spraying - Genie TMZ-34/19 Service Manual

June 2005
800-610-4101
ActionRental.com
REV B
Models with hydraulic outriggers:
1 Attach a lifting strap from an overhead crane to
the pad end of the outrigger. Do not apply any
lifting pressure.
2 Tag and disconnect the wire harness from the
outrigger limit switch.
3 Remove the pin retaining fasteners from the
outrigger pivot pin. Do not remove the pin.
4 Remove the pin retaining fasteners from the
outrigger cylinder rod-end pivot pin.
5 Place a rod through the hole in the outrigger
cylinder rod-end pivot pin and twist to remove
the pin. Remove the outrigger cylinder rod-end
pivot pin from the machine.
6 Secure the rod-end of the cylinder to the
chassis.
7 Place a rod through the hole in the outrigger
pivot pin and twist to remove the pin. Remove
the outrigger pivot pin from the machine.
Crushing hazard. The outrigger
could fall if not properly supported
when the pivot pin is removed
from the machine.
Crushing hazard. The outrigger
cylinder could fall if not properly
supported when the outrigger is
removed from the machine.
Part No. 52075
11-2

Outrigger Cylinder

How to Remove an Outrigger
Cylinder
When removing a hose assembly
or fitting, the O-ring on the fitting
and/or hose end must be replaced
and then torqued to specification
during installation. Refer to
Section 2, Hydraulic Hose and
Fitting Torque Specifications.
1 Extend the outrigger until the pad just touches
the ground. Do not rest the weight of the
machine on the outrigger.
2 Remove the cylinder guard mounting fasteners
from the rod end of the outrigger cylinder and
remove the cylinder guard from the machine.
3 Tag and disconnect the wire harness from the
outrigger cylinder valve coil.
4 Tag, disconnect and plug the hydraulic hoses
from the outrigger cylinder. Cap the fittings on
the cylinder.

Bodily injury hazard. Spraying

hydraulic oil can penetrate and
burn skin. Loosen hydraulic
connections very slowly to allow
the oil pressure to dissipate
gradually. Do not allow oil to squirt
or spray.
TMZ-34/19
Section 4 • Repair Procedures
OUTRIGGER COMPONENTS
4 - 49