Engines; Timing Adjustment; Rpm Adjustment; Engine Drive Pulley - Genie Z-34/22 Service Manual

April 2016
6-1

Timing Adjustment

Complete information to perform this procedure is
available in the Kubota Z482-E.
Kubota Z482-E3B Operator's Manual
Genie part number
6-2

RPM Adjustment

Refer to Maintenance Procedure in the appropriate
Service or Maintenance Manual for your machine,
Check and Adjust the Engine RPM.
Part No. 139234
6-3

Engine Drive Pulley

How to R emove the Engi ne Drive Pulley
How to Remove the Engine Drive
Pulley
1 Remove the engine pivot plate latch retainer.
139420
2 Open the engine pivot plate latch and swing
the engine out away from the machine to
access the engine drive pulley.
3 Loosen the tension adjustment bolt on the
generator.
4 Pull the generator away from the machine and
remove the belts from the generator pulley.
5 Remove the 3 bolts that attach the engine
drive pulley to the shaft bushing.
6 Install the same 3 bolts that were removed in
step 5 into the threaded holes of the engine
drive pulley.
Z-34/22 Bi-Energy
Service Manual

Engines

83