Emerson Micro Motion 3500 Installation Manual page 15

Refer to the label attached to the terminal block. See
•
•
The I/O terminal block ground is available for continuation of user cable shielding to I/
O cable shielding. The cable connector does not connect the I/O cable shielding to the
chassis ground.
Figure 3-4: Terminal block installation steps for I/O wiring on a DIN rail
Figure 3-5: Input/output wiring terminal label for I/O cables
Installation Manual
Use 24 to 16 AWG (0,25 to 1,5 mm
Ground the shields at a single point only
inches
3 3/64
(mm)
I/O terminal block
2 31/64
2 1/4
(63)
(57)
2 37/
Label
2 19/64
64
(59)
(66)
DIN rail type TS 15
DIN rail type TS 35 x 7,5
2 ) twisted-pair shielded wire
Cable for input/output wiring
Connector
(77)
9
(229)
2 15/64
(57)
DIN rail type TS 32
DIN rail type TS 35 x 15
Figure 3-5 and Figure 3-2.
I/O terminal block
3 17/32
(90)
Wiring
15