High Pressure Hose And Spraying Device - Kranzle W 11/135 Original Operating Manual

High pressure hose and spraying device

The high pressure hose and spraying device supplied with the machine are made
of high grade material. They are also optimized for the machine and marked as
required by the appropriate regulations.
If replacement parts are required, only such parts that are authorized
by the manufacturer and which bear the markings required by the ap-
propriate regulations may be used. The high pressure hose and spray-
ing device must be connected in a pressure-tight manner.
The high pressure hose may not be driven over, pulled excessively
or twisted. Make sure that the hose is not damaged on sharp edges.
Hose lines are wear parts. Guarantee is accepted only for manufactur-
ing errors, not for external damages.
High pressure hose lines and spraying equipment must not be
repaired, but replaced by a new hose or spraying equipment.
Unloader valve - safety valve
The unloader valve - safety valve protects the machine from a build up of excess
pressure, and is designed not to permit an excess pressure to be selected for
operation. The limit nut on the handle is sealed with a spray coating.
The operating pressure and spray rate can be steplessly adjusted by turning the
handle.
Replacements, repairs, new adjustments and sealing should only
be performed by qualified persons.
Take care that all screw connections are pressure-tight. A leakage
of gun, high-pressure hose or hose drum has to be repaired at once.
Leakages lead to an increased wear and to a possible malfunction
of the delayed motor cut-out.
Operator's task:
Prior to each usage of this liquid spraying device, the operator is obliged to
check if all safety relevant parts are in perfect working condition.
(e.g. safty valves, high-pressure hose, cables and connections,
spraying devices, etc. )
Description
5