Motor Protecting Switch; High Pressure Hose And Spray Device - Kranzle 1132 Operating Manual

Motor protection switch
The motor is protected from overload by a motor protection switch, which cuts out the
motor in the event of overload. However should the switch trip frequently, the cause of
the malfunction should be located and rectified (see page 11).
Replacements and inspection work should only be
performed by qualified persons when the machine is
disconnected from the power supply, i.e. with plug pulled
out from the electrical socket.

High pressure hose and spray device

The high pressure hose and spraying device supplied with the machine are made of high
grade material, they are also optimized for the machine and marked as required by the
appropriate regulations. (max. hose length 20 m)
If replacement parts are required, only such parts that
are authorized by the manufacturer and which bear the
markings required by the appropriate regulations may be
used. The high pressure hose and spray device must be
connected in a pressure-tight manner (without leakage).
The high pressure hose may not be driven over, pulled
excessively, or twisted.
The hose may under no circumstances be pulled over
sharp edges.
Defective high-pressure hoses must not be repaired (acc. to
DIN 20022) but have to be replaced by new hoses appoved by
the manufacturer.
Explanatory symbols affixed to the high-pressure cleaner
The high-pressure cleaner may only be operated in horizon-
tal position!
Operate high-pressure cleaner in horizontal position only.
Never direct the high-pressure jet at people or animals.
Never direct the water jet at power sockets or any other electri-
cal installations!
13