Table of Contents
Advertisement
Motor protection switch
The motor is protected from overload by a motor protection switch, which cuts out the
motor in the event of overload. However should the switch trip frequently, the cause of the
malfunction should be located and rectified (see page 11).
Replacements and inspection work should only be performed by
qualified persons when the machine is disconnected from the
power supply, i.e. with plug pulled out from the electrical socket.
High pressure hose and spray device
The high pressure hose and spraying device supplied with the machine are made of high
grade material, they are also optimised for the machine and marked as required by the
appropriate regulations.
If replacement parts are required, only such parts that are
authorised by the manufacturer and which bear the markings
required by the appropriate regulations may be used.
The high pressure hose and spray device must be connected in a
pressure-tight manner. The high pressure hose may not be driven
over, pulled excessively, or twisted.
The hose may under no circumstances be pulled over sharp edges,
since otherwise the guarantee is automatically void.
Total stop system
The Kränzle bully are equipped with an electrical Start/Stop control. Having connected the
high-pressure cleaner to the water supply and having connected the HP hose, switch the
machine "on" using the On/Off switch. A red light in the switch flashes.
The motor is started by opening the gun. The motor is switched off after the gun has been
closed. The high-pressure cleaner works in stand-by until the On/Off switch is switched to
"Off". The red light in the switch goes out.
Having switched off the machine shortly press the trigger to release the pressure to be able
to unfasten the HP hose.
13
Advertisement
Table of Contents
