Rgb Analog Input Module - Barco ELM R12 Owner's Manual

RGB Analog Input Module.

What can be connected to these inputs ?
RGB analog input terminals with separate Horizontal and
Vertical sync inputs(RGB-HV), with Composite sync
input(RGB-S) or with Sync signals on green(RGsB).
Remark
Always use an interface when a computer and local monitor
have to be connected to the projector. See 'slot 1' for
interfaces to be applied.
R
O n
Red
Gr‰ryÂsÇurÃvƒˆ‡Ã†vthy†
RGBS/RGsB analog : 5 x BNC
Red : 0.7 Vpp ± 3 dB
Blue : 0.7 Vpp ± 3 dB
Green : 0.7 Vpp ± 3 dB
1 Vpp ± 3 dB if sync on green
Vert. sync : 1 Vpp to 4 Vpp ± 3 dB
Hor. sync / Composite sync :
1 Vpp to 4 Vpp ± 3 dB
All input signals are always 75 ohm terminated, even in the "not selected" mode.
How to select the RGB input :
Key in the corresponding slot number on the RCU or the local keypad.
Sync selection on the Input Slots menu.
The horizontal sync input can be set as separate sync input or as separate sync + video input.
To change this setting :
1 Press ADJUST or ENTER key to start up the Adjustment mode.
2 Push the cursor key é or ê to select Installation (menu 1)
3 Press ENTER.
4 Push the cursor key é or ê to select Input Slots (menu 2)
5 Press ENTER.
6 Push the cursor key é or ê to select the corresponding RGB Input Slots (menu 3)
7 Press ENTER key to toggle between CV and CS or HS&VS.
5976072 BARCOELM R12 05052000
Downloaded from ProjectorsManual.com Manuals
B V
G
H / C
S B 7Ã6 I 6 GP B ÃDI QV U
Vert. sync
Hor. sync or Composite
sync
Blue
Green
Green Operation
Red Stand- by
Two way
hardwired Hardwired
remote
remote
CTRL 2
CTRL 3
Sync OK IR
Hardwired
remote RS232/422 IN
CTRL 1
R G B H / C V
O n
H ig h Ba ndw i d th R G B A N A LO G IN P U T
Diagnostic Code IR-Receiver
O U T IN
O n
RS232/422 OUT COMM PORT TRIGGER OUT
T 9 DÃ9DB DU6 GÃDI Q V U
R G B H / C V
69,'(2 9,'(2
On
W D9@ PDIQ V U
Hig h B a nd w idt h 5 C A B LE IN P UT
21
2))
O U T IN
O n
T 9 DÃ9 DB DU6 GÃDI Q V U
R G B V
H / C
O n
ÃD I U@S A6 8@Ã
DI Q V U 7 C
W
S B
DI Q DI Q
Connections
4-9