Operation - Sharp IG-CM1A Operation Manual

OPERATION

To operate
Remove the cap cover
1
Place the product by opening a stand
2
The stand can be opened at two levels of angle;
approximately 25 degrees and approximately 50 degrees.
Open the stand and place the product so the outlet turns
to you.
* The stand cannot be opened by more than 50 degrees.
Do not apply excessive stress to the stand.
The high-density Plasmacluster
ions reach approximately 80cm
point in wind blowing direction
from the outlet. If the stand
is closed, the high-density
P l a s m a c l u s t e r i o n s r e a c h
approximately 30cm point.
Set the operation switch to
3
turn ON
To stop operation
Set the operation switch to
1
turn OFF
Attach the cap cover
2
IG-CM1A.EN.indd 9 IG-CM1A.EN.indd 9
< Installation example >
E-7
[Lighting (blue)]
[ Lights off ]
2011/03/07 14:04:27 2011/03/07 14:04:27