Removing And Replacing Frus; Removing And Replacing The Power Supplies - Cisco ASR 1001-HX Hardware Installation Manual

Removing and Replacing FRUs

This chapter describes procedures for removing and replacing field-replaceable units (FRUs) from Cisco
ASR 1001-HX and 1002-HX Routers.
•
•
•
•
•
•
•

Removing and Replacing the Power Supplies

The following sections describes the procedures for removing and replacing the Cisco ASR 1001-HX Router
and Cisco ASR 1002-HX Router power supplies.
The Cisco ASR 1001-HX Router and Cisco ASR 1002-HX Router have redundant power supplies that
Note
can be hot-swapped.
The Cisco ASR 1001-HX Router has two power supply slots that are accessed from the rear of the chassis:
Note
power supply slot 0 (PS0) and power supply slot 1 (PS1) are on the left of the chassis power switch.
The Cisco ASR 1002-HX Router has two power supply slots that are accessed from the front of the chassis:
power supply slot 0 (PS0) is on the bottom; and power supply slot 1 (PS1) is on the top (next to the chassis
power switch). The removal and installation procedures are the same for both routers.
Removing and Replacing the Power Supplies, page 111
Removing and Replacing USB Flash Memory Stick, page 117
Removing and Replacing a DIMM, page 117
Removing and Replacing an EPA, page 128
Removing and Replacing Fans, page 131
Installing the Crypto Module, page 140
Repacking the Router, page 144
Cisco ASR 1001-HX Router and Cisco ASR 1002-HX Router Hardware Installation Guide
7
C H A P T E R
111