Cisco ASR 1001-HX Hardware Installation Manual page 70

Two-Post Rack Installation
Step 4 With two people, lift the chassis into position between the rack posts.
Step 5
Align the mounting bracket holes with the rack post holes and attach the chassis to the rack.
Step 6 Position the chassis until the rack-mounting flanges are flush against the mounting rails on the rack.
To allow space to attach the cable-management brackets to the chassis in the rack easily, use the
Tip
rack-mount bracket ear holes mentioned in Steps 7 and 8.
Step 7 Hold the chassis in position against the mounting rails in the equipment rack and follow these steps:
a) Insert the bottom screw into the second hole up from the bottom of the rack-mount ear and use a hand-held
screwdriver to tighten the screw to the rack rail.
Tip
b) Insert the top screw into the second hole from the top of the rack-mount ear diagonally from the bottom
screw and tighten the screw to the rack rail.
c) Insert the rest of the screws to secure the chassis to the rack equipment.
Step 8
Tighten all the screws on each side to secure the chassis to the equipment rack.
The following figures show the Cisco ASR 1001-HX Router and Cisco ASR 1002-HX Router on a two-post
equipment rack.
Figure 25: Cisco ASR 1001-HX Router Installed on a Two-Post Equipment Rack
1 Rack equipment rail
Cisco ASR 1001-HX Router and Cisco ASR 1002-HX Router Hardware Installation Guide
58
To make installation easier, insert one screw at the bottom of the chassis and the next screw at the
top of the chassis diagonally from the first screw.
2 Rack mount bracket ear and screws
Installing the Router