Workbench-Mounting The Switch; Wall-Mounting The Switch; Wall Anchor - H3C S5120-SI Installation Manual

(1) Front panel
NOTE:
If a rack shelf is available, you can use the rack shelf and mounting brackets to mount the switch in
the rack. Put the switch on the rack shelf and slide the switch to a position so that you can attach the
mounting brackets securely to the front rack posts.

Workbench-mounting the switch

CAUTION:
• Make sure the workbench is clean, stable, and is reliably grounded.
• Ensure a minimum clearance of 10 cm (3.94 in) around the switch.
• Do not place heavy objects on the switch.
If a 19-inch rack is not available, you can install the switch on a workbench.
To mount the switch on a workbench:
Place the switch with bottom up carefully, and clean the round holes in the chassis bottom with
1.
dry cloth.
Attach the rubber feet to the four round holes in the chassis bottom.
2.
Place the switch with upside up on the workbench.
3.

Wall-mounting the switch

The S5120-9P-SI, S5120-9P-PWR-SI, and S5120-9P-HPWR-SI switches support wall mounting.
You can use wall anchors to mount the switch on a concrete or wood wall.

Wall anchor

No wall anchors are provided with the switch. Prepare them yourself.
A wall anchor contains an expansion anchor and a screw. Use wall anchors with a diameter less than
4 mm (0.16 in) for wall-mounting the switch.
(2) Rear panel
10