H3C S5120-SI Installation Manual page 26

To connect an AC power cord for the switch that is not provided with a power cord retaining clip:
Insert one end of the AC power cord to the AC-input receptacle on the rear panel of the chassis,
1.
as shown in Figure
Connect the other end of the AC power cord to the AC power source.
2.
Figure 26 Connecting an AC power cord (1)
To connect an AC power cord for the switch that is provided with a power cord retaining clip:
Insert two ends of the power cord retaining clip into the retaining holes at two sides of the
1.
AC-input receptacle. Then pull the power cord retaining clip upward, as shown in
Insert the AC power cord plug into the AC-input receptacle, as shown by callout 1 in
2.
Then pull the power cord retaining clip downward to secure the AC power cord in place, as
shown by callout 2 in
Connect the other end of the grounding cable to the AC power source.
3.
Figure 27 Connecting an AC power cord (2)
26.
Figure 28.
18
Figure 27.
Figure 28.