Inspection Of Fidaptor - HIOS HM-10 Operation Manual

■ Inspection of Fidaptor

● Handling of Fidaptor
1. Never apply a load more than the measurement capability specified for Fidaptor.
2. Use Fidaptor appropriate for the screwdriver and the torque.
3. Always keep Fidaptor loose and remove everything from the socket after measurement.
4. Try to keep the screwdriver and Fidaptor upright while measuring and apply the thrust load of 5kg
or smaller.
(In the case of a lower range of torque, the thrust load should be 2kg or smaller.)
5. For continuous measuring, apply grease to the component parts of Fidaptor.
6. Set the measurement cycle to 5 seconds or longer. If you set the cycle to a time different to that,
the component parts will wear quickly.
7. Never leave or store Fidaptor in a fastened state.
When you don't use Fidaptor, loosen the spring.
8. Correctly engage the object for measurement and Fidaptor.
9. Don't use a deformed or modified Fidaptor.
● Maintenance and inspection of Fidaptor
1. Apply grease (*) to the components (1), (2) and (5) (see the figure below) of Fidaptor regularly.
2. Check the components below before you use Fidaptor:
1) The components (1), (2) and (5) have been greased.
2) The threaded shaft is not bent and the threads have not worn.
3) The threaded shaft is free from foreign materials.
3. Fidaptor is a consumable component. Inspect it regularly and replace it whenever required.
(1) Threaded shaft
(2) Bearing set
(3) Bearing housing
(4) Spring
(5) Plate nut
[Replacement guide] See the figure to the left for the
components (1)-(5).
Components (1) and (2) ： every 2,500 cycles (1 stroke =
1 cycle)
Component (1): when the shaft is bent or the threads
have worn.
Component (4): it should be replaced together with the
component (1).
Component (5): every 5,000 cycles
Note: The grease is available from HIOS. (Separately sold,
grease P/N: TF-3G)
- 10 -