HIOS HM-10 Operation Manual page 17

■ Specifications for analog output
It is about 12V at the maximum torque.
(Maximum torque: 9.81N ・ m for HM-100; 0.981N ・ m for HM-10)
● If you want to use it as an output unit for observed waveforms, you may need the devices below:
Oscilloscope, voltage meter, analog data collection system (Keyence), data logger (Hioki), etc.
Also prepare a dedicated cord for analog data output (P/N: HP-8060, 1.5m).
*Use the devices properly after reading the operation manuals attached to the devices.
■ Data output
If you want to transfer the data to your PC, please use the input tool of Mitutoyo.
A connection cable (separately sold) is also required to connect the input tool and the torque meter.
● Types of input tools
・ USB keyboard conversion type, P/N: IT-012U 264-012
・ Keyboard signal conversion type, P/N: IT-005D 264-005 (for DOS/V)
● Connection cable: IT937244, 5 pins, 2m
* For the input tool and the printer connection cable, contact Mitutoyo or your dealer.
Regarding import of measurement data, please contact HIOS.
- 16 -