Inventory - Grizzly G0811 Owner's Manual

Inventory

The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
Component Inventory (Figure 5)
A. Motor .......................................................... 1
B. Pulley Cover ............................................... 1
C. Work Stop Rod ........................................... 1
D. V-Belt .......................................................... 1
E. Control Panel .............................................. 1
F. Work Stop ................................................... 1
G. Pulley Cover Knob M6-1............................. 4
Fasteners (see Hardware Recognition Chart)
• Hex Bolts M12-1.75 x 50 (Frame) ............... 4
• Hex Nuts M12-1.75 (Frame) ........................ 8
• Hex Bolts M6-1 x 12 (Control Panel) .......... 2
• Flat Washers 6mm (Control Panel) ............ 2
• Hex Nuts M8-1.25 (Motor) .......................... 4
• Flat Washers 8mm (Motor) ......................... 4
• Lock Washers 8mm (Motor) ....................... 4
• Button Head Cap Screw M6-1 x 10
(Pulley Cover) ............................................. 1
• Hex Bolts M8-1.25 x 20 (Pulley Cover)....... 2
• Flat Washers 8mm (Pulley Cover) .............. 2
-14-
A
D
Qty
Figure 5. Component inventory.
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
B
F
E
NOTICE
Model G0811 (Mfd. Since 02/16)
C
G