2N EasyGate Pro User Manual page 42

Service
Hardware version
EasyGate hardware version - for information only (cannot be modified). Must be used
for communication with the manufacturer.
Firmware version
EasyGate firmware version - EasyGate central processor program version. The
manufacturer can issue upgrades to extend functions. To load new firmware into
EasyGate use the Upgrade function. Keep communicating with the manufacturer.
Serial number
EasyGate serial number - for information only (cannot be changed). Must be used for
communication with the manufacturer.
Blocked to operator
Refer to GSM & SIM Parameters.
COM enable (Function No.: 960)
With this parameter you can enable/disable the serial interface function. You can
disable communication in the operating mode, maintaining the special programming
mode after power up.
Setting options: YES/NO
Default setting: YES
Time limit for data connections (Function No.: -)
After time elapsing is data/fax connection terminated immediately without warning.
The "0" setting means that the function is disabled.
Setting options: 0-255 min
Step: 1 min
Default setting: 0
Telephone number for service SMS (Function No.: 714)
Telephone number for service SMS. The number is common for GGMC SMS and "LOW
CREDIT" SMS on prepaid SIM cards.
Setting options: 0-16 characters (0-9,*,#,+)
Default setting: blank
Time period for GGMC SMS [h] (Function No.: 970)
Time interval for GGMC SMS sending. GGMC = GSM Gateway Monitoring Centre. The
"0" setting means that the function is disabled.
2N TELEKOMUNIKACE a.s., www.2n.cz 42/70