2N EasyGate Pro User Manual page 39

Send if activated longer than [ms] (Function No.: 601)
Set the SMS activation time necessary for SMS sending. This parameter prevents SMS
sending in the event of short-time activation. If a "0" is selected, SMS is sent
immediately upon the input activation.
Setting options: 0-25500 ms
Setting step: 100 ms
Default setting: 0 ms
Timeout after sending [s] (Function No.: 602)
Set the Time of inactivity after SMS sending. During this timeout no SMS is sent even if
the SMS input gets activated. This prevents sending multiple SMS units in the case of
repeated activation of the input.
Setting options: 0-2550 s
Setting step: 10 s
Default setting: 0 s
GSM & SIM Parameters
GSM operator lock (Function No.:- )
Provider blocking is set by manufacturer in EasyGate. If EasyGate is blocked to a GSM
provider, no other GSM provider's SIM card can be used. If an unacceptable SIM card
is used, the GSM modules does not registered to GSM and the GSM network LED
flashes quickly on the EasyGate panel.
CLIR - incognito (Function No.: 701)
Sets the calling line identification restriction (CLIR) for outgoing calls from EasyGate.
Attention, before enabling it is necessary to activate this feature by GSM operator,
otherwise outgoing calls can be rejected by GSM network.
Setting options: -According to provider (0) - depending on how the function is
selected in the GSM network
-Activation (1) - ID is not sent.
-Suppression (2) - ID is always sent
Default setting: According to provider
Roaming enable/disable (Function No.: 702)
You can make EasyGate work even if it is registered to a foreign GSM network.
Setting options: -Disable (0) - The GSM module logs out of a foreign network and
attempts to register again in within 5 minutes.
-Enable (1) - EasyGate works in any GSM network.
2N TELEKOMUNIKACE a.s., www.2n.cz 39/70