2N EasyGate Pro User Manual page 22

EasyGate data uploading and storing, including firmware upgrade, are executed in a
special mode, in which EasyGate waits for about 3s after power up (all LEDs are on). If
instructed so by the PCManager UNI during this timeout, EasyGate remains in this
mode as long as it is necessary. If EasyGate is not reset after the PCManager UNI is
terminated, switch the system off and on again.
Installation and setting of EasyGate PCManager (Win7)
Connect EasyGate to the PC using USB connection. EasyGate must be switched
1.
off.
After connecting is the virtual serial port in PC installed automatically. I case, that
2.
the port doesn't install automatically and unknown device is detected, install
drivers by using file: Drivers/win/CDM20814_Setup.exe.
Find the number of virtual port using Device manager. Look at setting of COM
3.
ports and find port marked as USB Serial Port(COMn).
Install PCManagerSmG from CD.
4.
Run EasyGate PCManager, select the language on the upper bar.
5.
In menu Program
6.
number according information from point 3.
2N TELEKOMUNIKACE a.s., www.2n.cz
select Setup. Set the COM port – local and select COM port
22/70