2N EasyGate Pro User Manual page 27

DTMF during call (Function No.: 107)
When DTMF is transmitted in voice channel of GSM network problem with quality can
occur, because the GSM compression can damage the signal. You can set digital
transmission mode, than SmartGate mutes original DTMF signal from telephone line,
and instead of this transmits digital DTMF in signaling channel. This function can't
solve problems, when Easy Gate receives DTMF, it influences sending direction only
and it is active only when Easy Gate originates the call.
Setting options: Analogue – DTMF transmission trough voice channel without change
(0)
Digital – DTMF is muted in voice channel and is transmitted digitally (1)
Default setting: Analogue
Beep after dialing end (Function No.:103)
Select a beep to signal the end of dialing (beginning of outgoing call establishing).
Setting options: YES(1)/NO(0)
Default setting: YES
Signaling
Line reversal indication for call in progress (Function No.:110)
Select call in progress signaling by telephone line polarity reversal on FXS interface.
There is voltage of reversed polarity on the telephone line during the whole call.
Setting options: YES(1)/NO(0)
Default setting: NO
Tariff pulse when call starts/ends (Function No.:111)
Signaling of call start or end by tariff pulse.
Setting options:
None (0)- EasyGate doesn't send tariff pulse as signaling of callstart/end.
Call end (1) - EasyGate sends tariff pulse when call ends.
Call start (2)- EasyGate sends tariff pulse when call starts.
Call start and end (3) - EasyGate sends tariff pulse when call starts and ends too.
Default setting: None
2N TELEKOMUNIKACE a.s., www.2n.cz 27/70