Fujitsu PRIMERGY BX300 Operating Manual page 45

Installing the Hardware
Ê Mount the cover with passage opening on the front of the expansion area of
the rack as described in the Technical Manual of the corresponding rack (see
"Related Publications" on page 141).
Figure 10: Mounting cable guide
Ê Hang up the cable guide with cable clips into the associated openings of the
vertical support (1) in the expansion area of the rack.
I
Note that the cable guide must be placed level with the upper edge of
the support bracket.
Ê Place two plugwashers (see also figure 6 on page 29) in the holes of the rear
left support upright into the associated openings (2) and, while holding the
guide in place, fasten it with two screws (3).
I
If two PRIMERGY BX300 are installed directly on top of each other or
in the top location of the rack, the cable clips on the cable guide must
be removed from space reasons.
A26361-K863-Z102-8-7619
Rev. 8.0
Cabling the System
35