After Installation - Salus ST325TX Instruction Manual

Pressing the reset button on the thermostat and the receiver (RXST625 only) will clear the
RF address code and generate a new default code which will be saved into the internal
memory of the unit; there is no need to re-pair the receiver and thermostat. This is a quick
and easy way to directly link the units in many applications.
Replacing the thermostat batteries will not affect the RF code setting. Pressing and holding
the SYNC button on the receiver will however clear the RF address code saved into the
internal memory, and switch the receiver into learning mode, as previously described.

AFTER INSTALLATION

After completing installation and powering up the ST325TX for the first
time the programmable thermostat will behave in the following way:
All the indicators on the display and the backlight will be turned on.
After two seconds, the display will change to show the currently
installed firmware version.
The ST325TX will then operate in NORMAL mode and display the
current room temperature.
All programmable thermostat settings will have been returned to
default values.
If the Reset Button is pressed, the ST325TX will behave in the same way
as described above, except that any previously saved user settings
stored in the internal memory will be deleted and overwritten with the
default settings.
8 ST325TX INSTRUCTION MANUAL