Installation; Installing And Replacing Batteries - Salus ST325TX Instruction Manual

INSTALLATION

Please read the important safety information at the start of this manual
before you start to install the device.
The ideal position to locate the thermostat is about 1.5m above floor
level. It should be mounted in a location where the thermostat is
accessible, reasonably lit and free from extremes of temperature and
SURFACE MOUNT STAND SUPPLIED
draughts. Do not mount the thermostat on an outside wall, above a
radiator or in a location where it may be subjected to direct sunlight.
To ensure trouble free operation of the Radio Frequency (RF) signal, always ensure that the
programmable thermostat is mounted away from any possible sources of interference (such
as radios, TV sets, computers, etc.), and is not mounted on or in close proximity to large metal
objects. Installing the ST325TX in enclosed areas such as cellars and basements is not
recommended.

INSTALLING AND REPLACING BATTERIES

Installing or replacing the ST325TX thermostat batteries is a
straightforward operation, but does require you to open the case
of the thermostat.
To open the ST325TX case, undo the securing screw on the bottom
of the case (just to the right of the hole for the Reset Button):
After undoing the screw pull it forward until the screw stops
moving, then carefully separate the two halves of the case by
gently pulling in an upwards direction. Once the case has been
separated, the batteries should be visible:
Ensure that the batteries are inserted correctly, paying careful
attention to the polarity markings on the battery and next to the
battery holders. After inserting the batteries, refit the ST325TX case
and retighten the securing screw.
4 ST325TX INSTRUCTION MANUAL