Battery Installation And Replacement; After Installation - Salus PH60 Instruction Manual

Salus PH60 Manual 008_89 18/01/2013 11:09 Page 4
INSTALLATION
Please read the important safety information at
the start of this manual before you begin to
install the device.The PH60 is easily installed –
whether fitted as part of a new installation, or in
place of an existing TRV control head.

Battery Installation and Replacement

Installation of the batteries is a straightforward operation. Unscrew
the end cap from the PH60 body as shown in this picture, and
insert the batteries – please make sure that the batteries are
inserted correctly.
Push button to
gain access to
battery
compartment.

After Installation

After completing installation and powering up the PH60 for the
first time the controller will go through an adaptation procedure
to check that the valve has been installed correctly. The PH60 will
behave in the following way:
4
The PH60 is attached to the valve body by
screwing the locking collar at the base of the
controller onto the threaded section of the TRV
body, as shown in this picture. The locking
collar only needs to be tightened by hand – do
not use a spanner or pipe grips as you may
damage the PH60, TRV or both.
Please insert
batteries
correctly as
indicated.
PH60 INSTRUCTION MANUAL