Maintenance; Date - Time 1000; Flow Temp. (Flow Temperature Control) 2000; Comfort T (Desired Flow Temperature In Comfort Mode) 2018 - Danfoss ECL Comfort 110 Operating Manual

Maintenance

2 sec.
Enter the maintenance menus.
Date - time
It is only necessary to set the correct date and time in connection with the first use of the
ECL Comfort 110 controller or after a power break of more than 36 hours (see the chapter on
Adapting the ECL Comfort 110 controller).
Flow temp. (flow temperature control)
Comfort T (desired flow temperature in Comfort mode)
Setting the desired flow temperature for Comfort mode.
The same value is set in the End user menu as desired flow temperature when in Comfort mode.
Saving T (desired flow temperature in Saving mode)
Setting the desired flow temperature for Saving mode.
The same value is set in the End user menu as desired flow temperature when in Saving mode.
Temp. min. (minimum limitation of desired flow temp.)
Set the minimum flow temperature for your system. The desired flow temperature will not be lower
than this setting. Adjust the factory setting, if required.
Temp. max. (maximum limitation of desired flow temp.)
Set the maximum flow temperature for your system. The desired flow temperature will not be higher
than this setting. Adjust the factory setting, if required.
The setting for 'Temp. min.' has higher priority than 'Temp. max.'.
VI.LV.A1.02
Setting range
Setting range
Setting range
Setting range
1000
2000
2018
-20.0 . . . 50.0 °C
2019
-20.0 . . . 50.0 °C
2177
-20 ... 50 °C
2178
-20 ... 50 °C
© Danfoss | 2016.05 | 11