Danfoss ECL Comfort 110 Operating Manual page 43

Definitions in relation to cooling application
Pt 1000 sensor
All sensors used with the ECL Comfort controller are based on the Pt 1000 type. The
resistance is 1000 ohm at 0 °C and it changes with approx. 3.9 ohm / degree.
Return temperature
The temperature measured in the return can influence the desired flow temperature.
Typically, the return temperature to the cooling supply should not be too low. If so, the
desired flow temperature can be increased.
Room temperature
Temperature measured by the room temperature sensor. The room temperature can only be
controlled directly if a room temperature is measured. The room temperature can influence
the desired flow temperature.
Room temperature sensor
Temperature sensor placed in the room (reference room, typically the living room) where
the temperature is to be controlled.
Saving operation
Increased temperature in the cooling system controlled by the schedule. During less cooling
the flow temperature in the system is higher in order to save cooling energy.
Saving temperature
Temperature maintained in the cooling circuit during saving temperature periods.
Schedule
Schedule for periods with comfort and saving temperatures. The schedule can be made
individually for each week day and it consists of 2 comfort periods per day.
Time bar
The time bars illustrate scheduled periods with comfort temperature.
Disposal instruction:
This product should be dismantled and its components sorted, if possible,
in various groups before recycling or disposal.
Always follow the local disposal regulations.
VI.LV.A1.02 © Danfoss | 2016.05 | 43