GE IC754CSF15CTD Hardware User's Manual page 56

4
COM2 - Serial
The COM2 port is a general-purpose bidirectional serial data channel that
supports the EIA232C electrical standards. A DB9P (male) connector,
mounted on the bottom of the enclosure, provides standard signals as
described in the following table.
Shielding
Working with COM ports
To add a new remote networking connection
1. From the
up Connections.
The Connection window appears.
2. Double-tap
The Make New Connection window appears.
4-14
15" QuickPanel* View & QuickPanel Control Loaded Color TFT
Shielded cable is required for compliance with CE Mark and FCC
requirements. The cable shield should be connected to the metal connector
shell. Shield and signal ground (pin 5 of the 9-pin serial connector) should not
be connected directly together.
Start menu, tap
Make New Connection.
1 n/c
2 RX
3 TX
4 n/c
5 SG - Signal Ground
6 n/c
7 RTS
8 CTS
9 n/c
Settings and then
– December 2011
Network and Dial-
GFK-2402D