Akai MPC TOUCH User Manual page 134

Tap Presets to show or hide the preset sequence controls. These controls let you
manipulate and transform the velocities of the current bar in the sequence.
The first button will apply ascending or descending velocities to the steps. Each time
you tap it, it will cycle through these options:
•
The velocities will ascend to a single peak at the end of the bar.
•
The velocities will ascend to 2 peaks—one after each half of the bar.
•
The velocities will ascend to 4 peaks—one after each quarter of the bar.
•
The velocities will descend from a single peak at the start of the bar.
•
The velocities will descend from 2 peaks—one after each half of the bar.
•
The velocities will descend from 4 peaks—one at the start each quarter of the bar.
The second button will set the velocities of the steps to be at the maximum value (127) or minimum
values (1), depending on their position in the bar. Each time you tap it, it will cycle through these options:
•
The velocities of the first half of the bar will be set to 1. The velocities of the second half will be set
to 127.
•
The velocities of the first and third quarters of the bar will be set to 1. The velocities of the second
and fourth quarters will be set to 127.
•
The velocities of the first, third, fifth, and seventh eighths of the bar will be set to 1. The velocities of
the second, fourth, sixth, and eighth eighths will be set to 127.
•
The velocities of the first half of the bar will be set to 127. The velocities of the second half will be
set to 1.
•
The velocities of the first and third quarters of the bar will be set to 127. The velocities of the
second and fourth quarters will be set to 1.
•
The velocities of the first, third, fifth, and seventh eighths of the bar will be set to 127. The velocities
of the second, fourth, sixth, and eighth eighths will be set to 1.
134