Table of Contents
Advertisement
STEP 2
Install the Discharge Pipe onto the Pump ( All Models)
WEEP HOLE
Figure 2.1
STEP 3
3.1)
Install the foam gasket into the "gasket seat" at the top of the basin, refer to Figure 3.1 for details.
FOAM GASKET
DISCHARGE PIPE
PUMP DISCHARGE
SK2002
Installation of the Foam Gasket
OVERLAP DETAIL
Figure 3.1
© Copyright 2005 Zoeller Co. All rights reserved.
5
IMPORTANT!
BE SURE THAT WEEPHOLE
IS NOT DIRECTED TOWARD THE FLOAT!
Water stream will be visible from this hole during
pump run periods.
APPROXIMATELY 1/4" OVERLAP
FOAM GASKET
GASKET SEAT
GASKET SEAT DETAIL
BASIN
SK2003
Advertisement
Table of Contents
