Mounting Your Extractor - CDA 3S10BL Installation, Use And Maintenance Manual

Mounting Your Extractor

This appliance is designed to
recirculate air only, under no
circumstances should it be connected
to any ductwork or external venting
system.
When installing this appliance over a
CDA hob, the clearance between the
extractor and the hob must be equal
Gas: 650mm minimum
to or exceed 650mm. This instruction
Electric: 650mm minimum
overrides the instructions supplied with
the CDA hob. (The height should be
measured from the top of the hotplates
Fig. 5
or burners).
Where the extractor is to be installed above a non-CDA hob, the
instructions supplied with the hob may dictate that the height required
above the hob is greater than 650mm.
IN THE ABSENCE OF ANY INSTRUCTIONS SUPPLIED WITH A
GAS HOB, THE MINIMUM DISTANCE BETWEEN THE HOB AND
EXTRACTOR MUST BE AT LEAST 760mm.
12