Table of Contents
Advertisement
11. With an assistant supporting the
weight of the sphere, adjust the
height by sliding the outer hanging
tube up or down the inner one (Fig.
20).
12 Fix the height adjustment by locking
the three grubscrews on the tube
joining-piece (shown as in Fig. 15).
NOTE the security of the height
adjusting grubscrews should be
double-checked at this stage.
13. Pull the safety cable tight at the
lower end (pulling through the hole
"A" in Fig. 19), then tighten the clamp
on the safety cable against this face.
14. Make all necessary electrical
connections.
15. Slide the ceiling rose cover up to
conceal the fittings. This is held in
position by a single grubscrew (Fig.
21).
Fig. 20
Fig. 21
17
Advertisement
Table of Contents
