CDA 3S10BL Installation, Use And Maintenance Manual page 15

6. Select the smaller diameter hanging
tube and pass it through the ceiling
rose cover. Note that the end of the
hanging tube with holes in it needs to
be upper-most (Fig. 13).
7. Thread the power cable from the
sphere upward through the smaller
diameter hanging tube.
Important: Ensure that the power
cable exits through the larger hole in
the side of the tube near the top end
(Fig. 13).
8. Slide the upper hanging tube inside
the lower hanging tube (Fig. 14).
9. Tighten the three grubscrews to lock
the two sections of the hanging tube
together (Fig.15). Important: These
grubscrews must be fully tightened
as they support the weight of the
sphere.
Fig. 13
Fig. 14
Fig. 15
15