Mounting Your Extractor - CDA 3U10 Installation, Use And Maintenance Manual

Mounting Your Extractor

IMPORTANT: To mount this extractor correctly onto a wall, free
access to both sides of the appliance is required. This extractor is
therefore unsuitable for fitting in a location where it is butting up to a
side wall, fitting or other obstruction.
To mount the extractor onto a wall:
1. Use the template supplied to mark out four fixing holes in the wall,
then drill these using a suitable drill for the type of wall:
• Two holes for the top hanging brackets.
• Two holes toward the bottom for the lower angle brackets.
Note: The size required for the holes is dependent on the wall fixings
to be used. The screws supplied are suitable for solid masonry walls
only: Dedicated fixings (with large heads) will be required for dry lined,
partition or other types of walls.
2. Insert large headed screws into the upper two mounting holes in
the wall, leaving 2 - 3mm of shank
protruding from the wall.
3. Attach both the hanging brackets to
the body of the extractor using the
smaller screws supplied (Fig. 5).
12
Fig. 5