Table of Contents
Advertisement
Installation
1. Thread the safety cable upward
through the small hole in the ceiling
plate then downward through the
centre boss. Pull this tight so the end
nipple rests against the ceiling plate
(Fig. 6).
2. Pass the fixed wiring from the ceiling
through the large hole in the ceiling
plate (shown as "A" in Fig. 7) and fix
this plate to the ceiling using suitable
fixings. The ceiling fixings supplied
with this appliance are designed for
fitting to a solid masonry or concrete
ceiling. If mounting the appliance to
any other type of ceiling the installer
must:
•
Use their own expertise and
discretion to select suitable
fixings to support the weight of
the appliance.
` •
Ensure that the ceiling is strong
enough to support the weight
of the extractor: Strengthening
the ceiling as necessary is the
responsibility of the installer.
Fig. 6
A
Fig. 7
Fig. 8
13
Advertisement
Table of Contents
