Table of Contents
Advertisement
1
Step
Remove
Packaging
2
Step
Prepare
Water
Line
Built-In Refrigerator Installation Steps
CAUTION:
Refrigerator
is much heavier at the top
than at the bottom–be
careful when moving.
Remove outer carton.
–Carefully cut banding
at top and bottom.
–Remove
top cap.
-Slide out back corner posts (2).
–Slide carton off top of cabinet.
Remove toekick from back of refi-igerator and set
aside for later installation.
s Remove grille panel
frame from front of door, set
aside for later installation.
NOTE: IT IS NOT NECESSARY TO LAY CABINET
DOWN IN ORDER TO REMOVE
SKID!
. To remove skid, remove the four 7/ 16" bolts and
their brackets.
CAUTION:
DO NOT ATTEMPT
TO ROLL UNIT
OFF SKID.
c There are support blocks on the bottom
of cabinet
and door. They must be removed
before rolling
unit off skid or damage will occur.
Carefully tilt cabinet and slide blocks out from
underneath
cabinet, slide unit off skid.
When using a hand-truck,
handle from side only.
/
7/1 6" Bolts
s Route 1/4" OD copper
tubing between house
cold water line and the water connection
location.
Copper
tubing should be long enough
to
extend to the front of the refi-igerator. Allow
enough
to accommodate bend leading into the
water valve.
. Install a shut-off valve between the icemaker
water valve and cold water pipe in the base-
ment or a cabinet. The shutoff
valve should be
located where it will be easily accessible.
l\
Floor
Copper Tubmgy
&
o
7
Hide quick links:
Advertisement
Table of Contents
