The Appliance; Precautions; Supplied; Required - Monogram ZISW36DY Installation Instructions Manual

Table of Contents

Advertisement

Grounding the
IMPORTANT-(
Please read carefully)
Appliance
FOR PERSONAL SAFETY, THIS APPLIANCE MUST
BE PROPERLY GROUNDED.
The power cord of this appliance
is equipped
with a
three-prong
(grounding)
plug which mates with a
standard three-prong
grounding
wall receptacle
to
minimize
the possibility of electric shock hazard from
this appliance.
If the electrical service provided
does not meet the
above specifications,
it is recommended
that a
licensed electrician
install an approved
outlet.
DO NOT, UNDER ANY CIRCUMSTANCES, CUT
OR REMOVE THE THIRD (GROUND) PRONG
FROM THE POWER CORD.
DO NOT USE AN EXTENSION CORD WITH THIS
APPLIANCE.
DO NOT USE AN ADAPTOR PLUG WITH THIS
APPLIANCE.
Tools
Required
Tinsnips to cut
Level
#2 Phillips screwdriver
7/16"
socket with
3"
banding
" Appliance
Hand Truck
Stubby Phillips
extension
for rachet
Stepladder
. Tubing cutter
screwdriver
Safety glasses
c Bucket
7/16" open-end
wrench
Drill and appropriate
bits
Hardware
s
1-1/2" stamped open-
. Special plastic fastener
1/4" panel foam spacers
Supplied
end wrench
adhesive strips
. 1/4-1/4
union with nuts
Hardware
Water shut-off valve
Water filter
Custom panel for fresh
Side panels (see page 8)
Required
(optional
but
WR97X0214
(optional
food and freezer
Hardware for side
recommended)
but recommended)
compartments.
panel installation
Flooring
For proper installation,
this unit must be placed
CAUTION:
Protect the
on a level surface of hard material that is at the
finish of the flooring.
Cut
same height as the rest of the flooring.
This surface
a large section of the
should be strong enough
to support a fully loaded
cardboard
carton, lay on
refrigerator.
the floor in the area
where you are working.
Door
Clearance
Ii%quired
If the refrigerator
is to be installed in a corner:
A 2" min. clearance
between the case trim and
adjacent wall on both sides of the refrigerator
will
assure a 90° door opening
and access to all drawers.
An 8" clearance
is required
on both sides for
removal of pans.
6

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents